I need to check the interface card detail of a Cisco router, what command can be used? For Juniper, it's convenient with command "show chassis hardware", what's the Cisco equivalant of this? thanks.
Hi, I'm about to connect a brand new 3750 switch to our root switch now. I need to connect the trunk link and test the physical connectivity. if this new switch is not configure, will it causes problem? I've put "spanning-tree uplink fast" and "vtp m...
I got a terminal server with 2 octal cables attached to it. each octal cable has 8 RJ45 plugs. I installed a patch panel today and plug them into the back of the patch panel. I'll use the front panel as Out of Band ports. However I can't access other...
I got a terminal server with 2 octal cables attached to it. each octal cable has 8 RJ45 plugs. I installed a patch panel today and plug them into the back of the patch panel. I'll use the front panel as Out of Band ports. However I can't access other...
I have 3 routers connected to a switch, see diagram attached.R1 is set as the default gateway for R2 and R3, R2 and R3 has the same static routing configuration âip route 0.0.0.0 0.0.0.0 next hop on R1â. R3 can now ping R1 interface connected to ...