About Atasawar1

Atasawar1 · 07-01-2020

We have two data centers connected with only OTV link. All the network traffic flowing (extended vlans) are passing through OTV. We need to make L3 routing for few subnets which are configured on aggregation switches on both sites. How can we achieve...

Atasawar1 · 12-16-2017

Newly installed FMC virtual is not accessible through GUI. I can ping the FMC IP however, GUI is not accessible when I'm trying to reach FMC through https. Output of below commands is attached. Version: (Cisco_Firepower_Management_Center_VMware-6.2....

Atasawar1 · 08-13-2017

I have multiple Vlans on Cisco ASA. All of them have same security level. I have configured same-security-traffic permit inter-interface however still users of Vlan x are not able to ping users in Vlan y. If someone can help me out how to enable co...

Atasawar1 · 06-07-2017

In below connectivity scenario how I can provide IP addresses to my wifi clients. I'm configuring static IP config to my AP. Wireless Clients > Access Points > Access switch Access switch > Distribution switch (Layer 2 trunk) Distribution switch >...

Atasawar1 · 06-01-2017

We are implementing Cisco Prime Infrastructure 3.0 in our network. We are adding network devices in Prime Cisco and then we want to integrate with third-party NMS (Netcool). How to configure Prime Infrastructure to send traps and information receive ...

Atasawar1 · 12-18-2017

No this particular IP is not being used anywhere else in the network. I changed the eth0 IP and tried pinging the IP and in that case it was not pingable anymore.

Atasawar1 · 12-17-2017

It’s from VMware console. i will share the output once I’m at site. Thanks

Atasawar1 · 12-17-2017

Via virtual appliance console; sudo ifconfig eth0 x.x.x.x/x sudo ip route add default via x.x.x.x

Atasawar1 · 06-01-2017

You can trap receiver in Cisco Prime Infrastructure as shown in below image.

Atasawar1 · 06-01-2017

This is to inform you all if someone wonders that what happened to above-mentioned problem. There are four ports connecting to core switches from firewalls. I created single port-channel for all four interfaces connecting to all four interfaces two e...

Member Since	‎02-15-2014 09:07 PM
Date Last Visited	‎07-08-2020 08:41 PM
Posts	24
Total Helpful Votes Received	31

User Statistics

User Activity

L3 Routing For Specific Subnets Between two OTV Sites

FirePower Management Center GUI/https Not Accessible

Inter Vlan Routing (Cisco ASA)

WLC DHCP for wireless clients behind layer3 hop.

Cisco Prime Infrastructure 3.0 Integration

Re: FirePower Management Center GUI/https Not Accessible

Re: FirePower Management Center GUI/https Not Accessible

Re: IP Address Change - Virtual FMC

You can trap receiver in

This is to inform you all if