We have an ASA 551o that we use for VPN, both Client and PTP.I noticed a problem with one of the NAT settings on our OUTSIDE interface. The netmask is 255.255.255.218 and should be 128. I can't change it on ASDM as it is grayed out in the NAT setti...
I am having problems getting the LDAP authorization to work. None of the instructions I find seem to coincide with my version of ASDM 5.0(7) and ASA 7.0(7).SO if anyone has the right instructions for these version can you send me a link?I get as far...
We need to be able to access the Device via SSH while connected VIA VPN.I have added it to the management access:pix(config)#management-access insideAnd it says I need to add the correct access. I have SSH added to my ACL on the outside interface com...
Thanks for everyones help so far as I am very close to my goals but now I am stuck on something else.I have internet access but when I connect to my network via VPN I can not get to the internet (via http/ping etc) I get Address translation but no c...
Forgive me if this get confusing.I have a new ASA 5510, I have set it up for VPN use. I can vpn via IPSEC and connect to 2 of my subnets .0 and .64 (we have 4 subnets in our range) I can ping, http(s), connect to shares, SSH etc. I am using th...
Yes it is.I can SSH into it from anywhere on my network just not while connected to the VPN. I can Telnet to it and ping it while using VPN, just not SSH.
When I setup my split tunneling I made a standard ACL and that just says Permit my network. (and is working fine)Do I need a line just for my Inside interface?
I tried that with no luck. Just to make sure, I removed the management access and readded:ASA(config)# management-access inside-vpnPlease remove the management access before configure a new oneASA(config)# no management-access inside-vpnASA(config)#...
Actually my DHCP range was on its on subnet.I have resolved this issue and thanks for your help.I was creating the Split Tunneling and creating the ACL/ACE for it but was not actually enabling it on any VPN group.