About utkarsh.vijay.sawant

utkarsh.vijay.sawant · 09-20-2009

I need to check PIX cpu usage for last 1 or 2 hours.Any command for that ??"show cpu usage" only shows for last 5 minutes

utkarsh.vijay.sawant · 05-12-2008

I have 2 ASAs 5510 with same physical configuration and running ok with active/standby failover mode. Like we have PREEMPT command in active/active failover to get back primary active after its been rebooted from failed mode. This command makes prima...

utkarsh.vijay.sawant · 09-18-2008

Hi,To do VPN debugging on ASA, please use following commands.#debug crypto isakmp (phase 1)#debug crypto ipsec (phase 2)plus use following commands to troubleshoot#show crypto isakmp sa#show crypto ipsec saThanksUtkarsh

utkarsh.vijay.sawant · 06-10-2008

Hi Biplob,Farukh has explianed well, and I just want to add my thought for the same.Just add static route on pix towards router, and on router towards pix.Add ospf routes to router towards internet.As per me, no route redistribution required on route...

utkarsh.vijay.sawant · 06-01-2008

kindly send outputs of following show commands for troubleshooting:sh run isakmpsh run crypto ipsecsh run crypto map

utkarsh.vijay.sawant · 05-12-2008

For routers its possible to have failover by using HSRP, VRRP by using virtual IP.But we can do the same thing in Firewall in active/active failover without virtual IP.I just want some method to implement the same in active/standby failover. IF Any.

Member Since	‎04-01-2008 11:29 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

PIX "show cpu usage" for last 1 hour

Active/Standby failover automatic primary active

Re: Debug crypto commands

Re: Pix need dynamic routing ?

Re: [ERR]crypto map WARNING: This crypto map is incomplete

Re: Active/Standby failover automatic primary active