I am trying to mirror two ports on a SGE2000P switch. I have not set up any vlans but I keep getting an error that states Unknown value Port 4/g2 belongs to a vlan. My question is how do I get this error message when I have no vlans setup? Thank y...
I have numerous 802.11b cards that will not see the wireless network but 802.11g see it fine. I have set it up per the directions to make the 1.0, 2.0, 5.5, and 11.0 as the basic rate. What else do I need to do? Thank you for your help.
That was a good question and yes they are configured on index 1. I am just going to get the users new wireless cards. I have already put more time in this than the cost of the new cards. Thank everyone for all of your help. How do I need to close...
I input the info as you suggested unfortunatly it still does not work. I will paste my config agian but I do not see you had me configure. Do I need to do something to save the config? Thank you so much for your help.!version 12.4no service padser...
No problem at all. I tried what sanamon suggested but it did not work. When trying to type the first line of yours I would get an error after the dot0. The error is invalad entry pointed at the 0. Below is my config file now. Thank you for your ...