About silvio.lui

silvio.lui · 08-22-2013

Hi,I've a ring topology where run REP with Cisco ME-34xx and works fine. However I deployment others 'non-REP' switches in this ring. After do it, a fail betwen non-REP switches, dosen't change the REP topology and keeps the Aternated port in Block s...

silvio.lui · 08-22-2013

Hi, I've a ring topology where run REP with Cisco ME-34xx and works fine. However I deployment others 'non-REP' switches in this ring. After do it, a fail betwen non-REP switches, dosen't change the REP topology and keeps the Aternated port in Block ...

silvio.lui · 10-31-2023

You need disable NTP in the WLC and set the a time to before Dec/2022.Case after it the AP still get the same mensage "%PKI-3-CERTIFICATE_INVALID_EXPIRED", you should set the clock in the AP over console: clock set 19:00:00 Oct 30 2020

silvio.lui · 01-11-2022

Hello, It's considering that no RF signal loss happening, so could you try changing these in your WLAN as good practie to apple devices (probably not solve but improve the apple devices) Local Profiling ............................. Disabled --> Ena...

silvio.lui · 12-13-2020

Sounds like no comunication between the AP and WLC, as no CAPWAP response after broadcast requirement . If the WLC was not changed the firmware version (please ensure, because it would get incompatible SW), you could try it: 1- Ensure the WLC countr...

silvio.lui · 12-13-2020

If you are in the same L2 network to connect the RP port to both WLCs, you just need set any IP/Gateway (same broadcast must be the same gateway/subnet) to stablish the comunication. And go to set the "SSO" feature, so the secondary AP will auto st...

silvio.lui · 12-13-2020

Hi David, Didi you try it? wireless ewc-ap factory-reset

Member Since	‎05-16-2008 11:55 AM
Date Last Visited	‎03-20-2024 12:30 AM
Posts	14
Total Helpful Votes Received	30

User Statistics

User Activity

REP works with Non-Rep Switch issues

REP together Non-Rep Switch issues

Re: any chances to renew certificate at Access Point level

Re: iPad Connectivity Issues - Cisco 5520 WLC and 2802E Access Points

Re: Cisco AIR-AP1852 Failing to Join Controller

Re: High Availability Connectivity Using Redundant VLAN on WLC

Re: 9120 AP Factory Reset via CLI