Quick question, I seem to remember hearing that if you have 2 6500's each with dual sup's and MSFC cards running in SRM HSRP does not work between the 2 6500's. Can anyone verify this?Thanks.
I have a 6509 with MSFC2 and PFC2. We are accepting a route via eigrp of 10.95.116.0/22. This is known via an address on int. VLAN152. I have added a static route of 10.95.117.0/24 with a destination to a router on vlan 24. This static route does not...
Does anyone know why entries in the change audit report are showing an "unknown" username and hostname? This is happening in several other reports. Thanks.
Can anyone provide tips on how they manage their syslog_info file on RME under Solaris? My system has only been up for a month or so now and the file is 580MB. Thanks in advance.Erik
Using netconfig in CiscoWorks I cannot get a sucessful upload of the banner message. It appears that netconfig skips right over this part of the configuration. Has anyone run into this before?Thanks,Erik
Thanks for the info. All signs show that SRM is configured correctly. What I am seeing is if the MSFC on SUP(A) goes down, the MSFC on SUP(B) takes over. However since the actual SUP(A) is still up SUP(B) stays in a down state. What I think is happen...
Thanks for all the posts on this. From what I can tell the post from jackson was correct. I resubnetted my destination route and the entry now shows up.Thanks!
Yes "177" was a typo. The nexthop for the static is in the table. Here is some additional info:G03-MSFC1#sho run | i static redistribute static distribute-list 72 out static redistribute static distribute-list 61 out staticG03-MSFC1#sho ip route 10.9...
Thanks for the reply,I'm running RME 3.5 with the latest IDU. I am seeing the "unknown" username and hostname from all three of your scenarios. The most recent one was made by one of engineers when he changed a VLAN on a switchport. What do you mean ...