About gwoodyard

gwoodyard · 03-16-2005

Is it possible to run MGCP on a voice gateway concurrently?I am currently running H.323 and SIP on my 3745 without any issues.I have been told that I need MGCP to utilize Q.SIG support with CallManager and that MGCP may not work well with H.323 and S...

gwoodyard · 03-23-2005

Tony, I am curious why you choose to use "connection Tie-line 65 " rather than use dial-peers. You would not need to worry about signaling timeslot 15 because it is locally significant with dial-peers. I believe that dial-peers would give you flexibi...

gwoodyard · 03-22-2005

I am using T1 PRI with Q.SIG. The other end could be any type of voice port such as E&M, FXS, or T1 PRI.This is basicly my config. The PBX adds 21 & 41 as an access code and so that I do not overlap dial-peers.hostname voice-rtr!!isdn switch-type pri...

gwoodyard · 03-18-2005

This is fairly easy to do with two voice enabled routers with a PRI interface. You will need to configure each router with a voip dial-peer and pots dial-peer. The voip peer ships the call over the IP network (WAN) and the POTS peer will receive the ...

gwoodyard · 03-16-2005

Would it be possible to change the forwarded digits and then use those digits as the password?

gwoodyard · 11-06-2001

Looks like it's only supported in 7200s1 Port E3 Serial Port Adapter with E3 DSU PA-E3=

Member Since	‎10-25-2001 07:57 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	35

User Statistics

User Activity

H.323, SIP and MGCP?

Re: anyone linking PBX E1 across a WAN ?

Re: anyone linking PBX E1 across a WAN ?

Re: anyone linking PBX E1 across a WAN ?

Re: Automated door/gate opener and DTMF

Re: 3640 WAN interfaces