Yes, In the event action filter configuration configure the signature range , victim IP address and the action to subtract.

Hi Santosh, The Error messages you see are expected due to the password choice and the  behavior cannot be altered. 1.  John123      Did you try this by changing the size range value ( minimum default is 8 ) ? If you change it to 6/7, then you woul...

Hi Santosh, You see the errors even though both the passwords are as per the policy you applied ?  Is it possible for you to share the configuration ? steps ? tec. Thanks and Regards,Gaurav.

Login to CLI , then : conf t > service authentication > password-strength You can set your password policy. From GUI: Configuration> Sensor Management > Password. Hope this helps.