Hi, never configured a BGP route to be advertised across a VRF before so thought I'd learn.  I have configured the following attached, but for the life of me, I cannot figure out why it is not passing routing updates to each other. Is it something si...

I can see it is easy to configure IP NAT redundancy on 3700, 7000 series devices, but how do I configure it on a 6500 series switch ??The other systems basic command is  ip nat inside source static 1.1.1.1 .2.2.2.2  redundancy hsrp1  then you associa...

HiI have had 2 x Cisco 11503 Content Switches delivered and they have been configured and installed. It seems though, that whilst we telnet into each device via the management port, during the session, the management port freezes, stopping all traffi...

I know how this basically works. Both sides have a private key. Then each side sends it's public key which can only be decoded by the private keys.My question is,Each side, after working out the private/public key exchange, has to end up with the sam...

I know how to configure it, but I just want to ask a basic question about it and what I have configured.Say I redistribure OSPF into RIProuter ripredistribute ospf 2I have set the OSPF redistribution into a RIP metric with 2 hops. Can someone go into...