Is there a way to display the spanning tree status of the ports on a BR350?

We are looking to connecting 3 networks together using BR350 bridges in the following configuration. Network A (root) -- Network B (non-root) -- Network C (non-root)During testing we see good throughput from A<->B and A<->C but it is cut in half for ...

I read where the 802.1q standard allows trunks to be put on a shared medium. I have always setup trunks in a point-to-point to configuration but we have a need to setup a single trunk between 3 or more devices. The Config we are considering resemble...

What's the history behind the 802.11b channels allowed in Japan? I have read where the IEEE Std 802.11b-1999 standard said only channel 14 was allowed. I have also seen several documents; Cisco’s included, that all 14 channels are allowed. I under...

I'm setting up 6-10 wireless bridges (Aironet 350s) to connect segments together with no one being the "main" segment. There will not be any clients associating with these bridges. The manual says you must have one Root Bridge and shows a point to m...