About netadmin

netadmin · 11-17-2004

Hello! I was looking to convert a L2 6506 by adding a new MSFC to a L3 switch. I'm in the process of creating vlan's on the router module. Is there a guide/how to that I can use? My other 6509 is already a L3 with HSRP configured. Is HSRP required on...

netadmin · 11-17-2004

Even though both 2600 and 2950 are full duplex capable, every now so often I have run into mismatches or half/full issues on auto setting. A cleaner fix is to lock both ends to 100/full and you will see better communication.Also, it may have already ...

netadmin · 11-17-2004

You did mention that you are using a cross-over cable between two switches, correct?

netadmin · 11-17-2004

I had a similar unknown reboot on my 4503 in the middle of the night. There was no apparent hardware or config failure. The only solution I found (from Cisco) was to upgrade the IOS which I did. It has run very smoothly since. There was not enough do...

netadmin · 01-18-2001

We had a similar issue last year with NetWare communication and authentication of conduits to NDS. A Cisco security representative responded that neither Novell or Microsoft would share their authentication API's. This leaves three options: use th...

Member Since	‎01-18-2001 10:52 AM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	5

User Statistics

User Activity

Configure 6506 to L3!

Re: Ethernet Interface problems

Re: 3550-12G + 3524 using Gigabit-over-Copper = Not working.

Re: Cat 4006 Switch Reload Urgent

Re: Pix authentication other than ftp,http and telnet