About jeremybrainard

jeremybrainard · 11-24-2010

I have a 2901 (config snippets below) with an HWIC-4ESW-POE in Slot 0. I also have other switches down stream off of g0/1. The problem is that I can not get network devices (phones or computers) to work when I plug them in to the HWIC-4ESW-POE in S...

jeremybrainard · 11-24-2010

I used the "ip unnumbered" structure as noted, and the ports on the 4ESW work perfectly. The switch, a 2960 on Gi0/1 is not. Is there any modifications I need to make to the configuration of the switch?

jeremybrainard · 11-24-2010

No Luck... Unless I'm missing something, the Switchport command is unavaliable on Gi0/1. Possibly because it's a L3 port? G0/0 and G0/1 are built in to the router.

jeremybrainard · 11-24-2010

Am I still able to use Gi0/1 to connect to an external switch? or does everything need to be plugged into the HWIC card in Slot 0?Thanks Again

jeremybrainard · 11-24-2010

Got it...Never used SVI configs before. Is it similar to using Sub-Interfaces?You were correct, I did have the VLAN's configured on the router, and I was using Fa0/3/0.I've adjusted the interfaces (configs below), but I'm still not routing traffic t...

Member Since	‎11-23-2010 10:38 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

2901 with HWIC-4ESW-POE

Re: 2901 with HWIC-4ESW-POE

Re: 2901 with HWIC-4ESW-POE

Re: 2901 with HWIC-4ESW-POE

Re: 2901 with HWIC-4ESW-POE