Greetings,I'm in need of multiple gigs of bandwidth between two 6500s.As far as I see it I have 3 options:Take 3 1Gb circuits, configure them as individual layer 3 interfaces and use OSPF/CEF to loadbalance traffic.Take 3 1Gb circuits, configure them...

I'm looking to configure policy-maps to implement bandwidth levels and I had a question:Using police command, what does the burst subcommand actually affect? Is this the amount of bandwidth that can exceed the average rate?

I currently have 2 nodes connected via single OC48 (used to carry 2 gige circuits). Node 1 uses the internal clock for timing, Node 2 is looking to the line for timing. Currently this config seems to work fine. Now i need to bring up a second oc48 fr...

I have a need to modify the Source-IP in the HTTP header to report the client and not the loadbalancer IP. I've attempted to use the method listed in the documentation, however the client IP is not being logged:module ContentSwitchingModule 5 vlan 1...

Is it possible to loadbalance servers located in multiple VLANs using the CSM? I have a need to loadbalance sites the may be located in different VLANs/Subnets but I am unable to consolidate them into a single subnet.