About beyonddisability

beyonddisability · 12-22-2010

Hii all,I have a problem with a NM-ESW-16 network module in a Cisco 2651XM router running Advanced Security IOS v12.4(25d).Prior to upgrading to this version of IOS, the router was running IOS v12.4(8). Switch ports 0-7 were configured to be in VLAN...

beyonddisability · 12-22-2010

Hi Alain,I will try these things as soon as I can.Unfortunately I don't have physical access to this network without getting permission first, so I'll request to go in and do some more tests and report back. It could take a few days or more (thanks ...

beyonddisability · 12-22-2010

Hi Alain,If you wanted to ping an interface on switch module you would have to put that port as a L3 with no switchport command and then assign ip address.if you want to ping a stationA in vlan 1 from a stationB in vlan 1 then you are just doing L2 i...

beyonddisability · 12-22-2010

Hi Alain,I'm not sure if you're understanding the problem I'm having here or not, so I've tried to describe how I think it should work. Maybe you can tell me where I'm wrong, but please don't tell me its because I don't have an IP assigned to the vl...

beyonddisability · 12-22-2010

Hi Alain,Ok. Thanks.Why is it that I can ping anything else on the network though?The setup is pretty simple, just in case I wasn't clear:Cisco 2651XM has IP 10.92.184.1 on FastEthernet 0/0Also has the NM-ESW-16 module installed (FastEthernet 1/0 - ...

beyonddisability · 12-22-2010

Hi Alain,I'm not trying to get interVLAN routing going or anything of that nature, all I'm trying to do is use the 16 switch ports as two 8-port "dumb" switches, nothing more than that. They are working in this way at present but since the IOS upgra...

Member Since	‎12-22-2010 12:43 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	6

User Statistics

User Activity

Help configuring a NM-ESW-16

Re: Help configuring a NM-ESW-16

Re: Help configuring a NM-ESW-16

Re: Help configuring a NM-ESW-16

Re: Help configuring a NM-ESW-16

Re: Help configuring a NM-ESW-16