PLEASE I NEED HELP MY 2 T1 PRI's I SETUP THE 2 PRIs WHICH WAS CONNECTED TO MY PBX, CONTROLLER T1 1/0 IS DOWN AND CONTROLLER T1 1/1 IS UP THE COFIGURATIONS FOR THE 2 TI PRIs LOOKS THE SAME BUT I DON'T KNOW WHAT IS THE PROBLEM. CAN ANY ONE HELP ME RESOLVING THIS PROBLEM.
Do a "show controller t1" command and see what kind of alarm you are getting. If it is no signal, it could be your cable or a bad connecter at either ends. Other alarms are primaryly due to incompatible configuration on one end of the link. Good Luck
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.