I'm trying to set up a 2800 ISR as an H.320 video gateway. The 2800 is registered with H.323 to CM7 and is using an E1 to connect to the PSTN.The idea is that users with VT Advantage as well as a Tandberg VC H323 endpoint can all use the gateway to make video calls over the PSTN.
So far following the documentation we've managed to get 5 channels that appear to come up but the H323 tandberg just carries on ringing. Has anyone had any success in getting something similar working. All examples tend to refer to a gatekeeper but we shouldn't require one to get this going.
You are right you dont need a GK for this. basically if you are able to bond 5 channels then h320 bonding seems to work. I would like to see the debugs but may be first check the configuration using this document
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.