Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3640 VoIP to Nortel VoIP

I have a Point-to-Point WAN using T1s. I have at the host location a Northstar connected to a 3640 via a T1 (NM-HD), and the remote sites 1751 with E&M trunks to a Northstar. All of this works fine, we added a new site with a Nortel BMC 50. I can make calls from the host site to the site with the BCM 50 but can not make calls from the BCM 50 to the host site. Any help?

2 REPLIES

Re: 3640 VoIP to Nortel VoIP

Hello,

did you configure your dial plan everywhere correctly, so does the BCM50 know where to signal calls to and which IP addresses to use?

What are the error messages you receive, when dialing in the not operational direction?

Hope this helps! Please rate all posts.

Regards, Martin

New Member

Re: 3640 VoIP to Nortel VoIP

Hi!

We have the some problem.

I analize the traffic, but i can see that the Nortel BCM50 not understanding the Alerting.

If you place a call from BCM50 to Cisco Router, not hear ringback, and when you pickup the phone, the call drop after 5 seonds.

We have this problem with Nortel BCM50 and Nortel CSE1000S, but not with BCM400, the diference is the S.O.:

BCM50: Linux

BCM400: Windows NT 4.0

CSE1000S: Unix.

We have search resolution in our LAB.

If we will found a resolutio, we post them.

Regards.

118
Views
0
Helpful
2
Replies