802.1q trunk b/w 8PoE switch integrated in 1861 CME
I have to deploy cme7.0 (1861). Actually two 1861 routers are bought but only one of them act as cme while the 8PoE integrated switch of other 1861 is used. half of the IP phones are connected to the 8PoE integrated switch in CME (1861 router) while half of the phones are connected to 8PoE of 1861 (only 1861's PoE is used in this setup). i want to know whether i can cascade the two switches or in other words whether i can form a 802.1q trunk b/w these switches to carry the voice and data vlans.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.