I am having trouble connecting to a Cisco 3540 Gateway.
I dial out ISDN to a ISDN - IP Gateway that is setup to use IVR. At this point since the ACCORD bridge cannot enter an extension number the call drops to the default queue. Once the call hits the default queue it will connect audio only at 64k, no video. Any suggestions would be welcome.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.