Allow local,ld and a specific international country codes
I have a hub and spoke voip network that is made of legacy PBX's connected to Cisco VOIP router and at the Hub is the same setup. I have been asked to provide a cheap voip service to the remote offices VONAGE router with a cisco dial peer connected back to the remote sites.I have configred the remote sites with dial-peer as below
dial-peer voice 2 voip
description Vonage test
session target ipv4:10.1.0.23
playout-delay maximum 200
playout-delay nominal 100
playout-delay minimum low
codec g729r8 bytes 60
and at the Cisco Vonage gatway I have few FXO's with the below steup.dial-peer dial-peer voice 3848 pots
everything is working except they want me to allow country codes that are free to dial and deny the rest.
country codes 44 and 23 are allowed and the rest are denied. I am having hard time with this since all of my work on this has been resulted in allowing all international calls. Please I need your help on this.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...