Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Application & QoS

Hi friends,

I have a question for you.

I work with an application that runn over telnet protocol. I have a link with 2 Mb BW, and I need that this application only uses a 50% of 2 MB=1MB, but I have others application that are prioritaries over this telnet application, so, if others application need to use more BW that 1 MB, can use without problems. How can Implement it? Which QoS feature can I use?

Regards and Thank you very much

3 REPLIES

Re: Application & QoS

You will want to use traffic policing to limit the bandwidth used by telnet. This is done by creating a class-map that matches telnet traffic, creating a policy-map that polices traffic in the class map and assigning the policy-map to an interface with the service-policy command. Take a look at the following link.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5014/products_feature_guide_chapter09186a00800ca4f2.html

Hope this helps. If so, please rate the post.

Brandon

Re: Application & QoS

Hello,

you could use a combination of CBWFQ and shaping. Shaping limits an application to a maximum bandwidth. The advantage over policing would be no dropped packets - instead they are queued. CBWFQ gives minimum bandwidth guarantees to applications. An example config could look like this:

class match-all Telnet

match protocol telnet

class class-default

match any

policy-map OUT

class Telnet

shape average 1024000

class class-default

bandwidth 1500000

interface Serial0

bandwidth 2048

service-policy output OUT

Instead of class-default you could use another class describing your priority applications.

Hope this helps! Please rate all posts.

Regards, Martin

New Member

Re: Application & QoS

Thank you very much, with this config..Telnet aplication can use more than 1 MB of BW?? The rest of application can use more than 1 MB??

Best regards

415
Views
0
Helpful
3
Replies