Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Boot problem on 5350

I have a problem on booting a 5350. I connect it to Console cable and I tried to connect by Hyper terminal 9600/8n1 / none , but I can not see anything on the screen.

Is there any way to reset the cisco to factory default in this case?

how can I get ROMMON prompt to configure the Cisco in 0x2142 mode ?

Any soluiton ?

  • Video Over IP
1 REPLY
Silver

Re: Boot problem on 5350

Try using the Cntrl+Break sequence to get into rommon. Here is a document on the standard break sequences.

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

137
Views
0
Helpful
1
Replies
This widget could not be displayed.