OK so I've been trying to come up with the best way to do this for quite some time now.
I have two independent networks; an MPEG/IP network that I administer as well as the local network which my IT department administers. These two networks are completely separate from one another physically but I would like to be able to configure a single port on the MPEG/IP network and connect it to the local network so I am able to administer the MPEG/IP network from the local network. Currently I have to move my PC and physically connect into the MPEG/IP network to administer it. The local network is on a completely different subnet as well.
What is the best way to do this? I don't want my MPEG/IP network to see spanning tree changes from the local network and I don't want the unicast/multicast data from the MPEG/IP network to spill onto the local network. All I need the port on the MPEG/IP network to do, is allow administration of the switch cluster.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...