A client is looking to stream a C40 and C90 live between 2x points. They are very concerned over time lag. Can you tell me what the potential lag between the 2x codecs on a 10gb network would be. Would it be possible to allow the client to measure this lag (they have their own equipment to do this) between 2x codecs in a sample site.
And finally, is there a sync clock between audio and video to ensure that there is minimum sync issues between video and audio. I note that the Data sheet for both codecs says under "IP Network Features" there is Dynamic playout and lip-sync buffering and under audio features it says "Active lip synchronization". Are these automatic adjustments or is there a way to adjust manually as well?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...