Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

call transfer and pickup to CME FXS port

I have analog phone which connected to CME router's FXS port and problem on call handling(transfer and pickup) from CCM site.

CCM--gatekeeper--CME

dial from CCM to CME's ephone works okay but doesn't for the FXS port.

-CCM dial to CME's ephone and transfer to FXS attached analog phone. fast busy

-CCM dial to CME's FXS attached phone. ringing the analog phone and try pickup from CME's ephone. not works.

CME router IOS=12.3(8)T7. I configured transfer-pattern to transfer the call to the non-ephone device but no luck.

Thanks in advacne,

5 REPLIES

Re: call transfer and pickup to CME FXS port

Would you mind to post your config?

Thanks,

Brandon

New Member

Re: call transfer and pickup to CME FXS port

Follows my configuration related to the FXS port.

!

version 12.3

!

voice-port 2/0

station-id name Project-Room

station-id number 41664612101

!

voice-port 2/1

!

telephony-service

load 7910 P00403020214

load 7960-7940 P00305000301

max-ephones 20

max-dn 40

ip source-address x.x.x.x port 2000

auto assign 1 to 2

create cnf-files version-stamp Jan 01 2002 00:00:00

dialplan-pattern 1 4166462... extension-length 4 extension-pattern 2... no-reg

max-conferences 4

call-forward pattern .T

transfer-system full-consult

transfer-pattern .T

transfer-pattern 2...

!

Thanks,

Re: call transfer and pickup to CME FXS port

Do you have a dial-peer configured to point to port 2/0? Can you post that config?

Brandon

New Member

Re: call transfer and pickup to CME FXS port

dial-peer voice 2101 pots

destination-pattern 2101

no register e164

port 2/0

!

dial-peer voice 21011 pots

destination-pattern 41664622101

no register e164

port 2/0

!

Re: call transfer and pickup to CME FXS port

Enter the following commands to allow H.323 to H.323 connections:

voice service voip

allow-connections h323 to h323

exit

Take a look at the following link.

Enabling H.323-to-H.323 Connection Capabilities

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_feature_guide_chapter09186a00802c4a55.html#wp1000942

Brandon

642
Views
0
Helpful
5
Replies