I currently have LDAP integration enabled on my CM but now need to add users from another domain. Since I don't believe CM will allow me to use LDAP to another domain, can I disable LDAP without it automatically deleting all of my current End Users?
When the LDAP sync agreement is removed, all the end users that it pulled in will be marked inactive. Later on, when DirSync garbage collection takes place (normally on a daily basis) then all the inactive users are removed.
I think you can keep the users from being deleted from CUCM by disabling the DirSync service so that garbage collection doesn't happen. However if you enable the Dirsync service enay user marked inactive will be deleted
Please rate useful posts
"I am complete in God, God completes me"
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...