Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CALLMANAGER-QSIG-GF-ALCATEL-4400

Hi all,

I'm having the folowing senario,

PSTN-->CISCO-GW-2821---->CALLMA-(QSIG-GF)----->ALCATEL-4400.

When same one from the pstn call to a DN on alcatel 4400 the alcatel 4400 responds to a setup from the callmanager with a CALL-PROC folowed by a ALERTING with PI=8 and folowed by a PROGRESS with a PI=8. With the alerting with PI=8 the pstn does not open the audio channel. The alcatel 4400 as a feature (connect on progress) that generate a connect message in the presence of a progress message. On the cisco does any one knows a equivalent feature on the cisco side to send the connect message to the pstn based on the receiving progress from the alcatel.

Many thanks

3 REPLIES
New Member

Re: CALLMANAGER-QSIG-GF-ALCATEL-4400

Hi all,

I have similar problem. Does anyone find a solution?

Thanks in advance

New Member

Re: CALLMANAGER-QSIG-GF-ALCATEL-4400

Hello:

Have you tried to use this comand in the GW cisco?

In the pots outbound dial peer:

progress_ind progress enable 8

Hope this helps, please rate post if it does!

New Member

Re: CALLMANAGER-QSIG-GF-ALCATEL-4400

Hi all,

The only way to resolve the issue was using

a a feature "connect on progress" on alcatel side.

465
Views
0
Helpful
3
Replies