CallManager with Tandberg MXP990 configured as H.323 endpoint
I have a Tandberg MXP990 configured as an H.323 client in CallManager, I am running CCM 4.0.2, I am running into two issues and wonder if anybody has seen these before.
1. when on a call between a Cisco VTA and the Tandberg by dialing 4-digit extension. When I put the call on hold from the Cisco VTA the video stream from the Cisco VTA got disconnected but the voice stream was still going when I press resume. Is this a normal behavior ?
2. I do have multipoint enable on the Tandberg but for some reasons I can only connect up to 3 parties on a call. How can I get more than 3 parties on a call ?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...