Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can not access fxo in 2611XM

I have a 2611XM with NM-2V and Vic-2xo module. The router runs advance enterprise feature 12.4-21a. The router is able to recognize both NM-2V and Vic-2FXO module but I can not access the voice-port interface mode to configure the FXO. Is there any command I can type to activate the FXO ? Or is there any other problems? I have tried different IOS and the result is the same. Here is the show diag for your reference:

Slot 1:

4 PORT Voice PM for C2600 Port adapter

Port adapter is analyzed

Port adapter insertion time 1w5d ago

EEPROM contents at hardware discovery:

Hardware revision 1.1 Board revision H0

Serial number 24256275 Part number 800-02491-02

FRU Part Number NM-2V=

Test history 0x0 RMA number 00-00-00

EEPROM format version 1

EEPROM contents (hex):

0x00: 01 65 01 01 01 72 1F 13 50 09 BB 02 00 00 00 00

0x10: 88 00 00 00 01 01 03 17 FF FF FF FF FF FF FF FF

0x20: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x30: FF FF FF FF FF FF FF FF FF FF FF FF

VIC Slot 1:

FXO Voice daughter card (2 port)

Hardware revision 1.1 Board revision K0

Serial number 29226198 Part number 800-02495-01

Test history 0x0 RMA number 00-00-00

Connector type Wan Module

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 0D 01 01 01 BD F4 D6 50 09 BF 01 00 00 00 00

0x30: A0 00 00 00 02 09 24 01 FF FF FF FF FF FF FF FF

1 REPLY
Hall of Fame Super Red

Re: can not access fxo in 2611XM

Hi Chun,

It sounds like you do not have any DSP resources.You will need something like a PVDM2-8 card on the motherboard to provide DSP resources to the FXO card. Without DSP resources you cannot configure the FXO :)

Here is a link to the DSP Calculator

http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

Hope this helps!

Rob

193
Views
0
Helpful
1
Replies