Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAS/SIP configuration

Hi All,

Using the cisco router (2900 series) as an SIP to E&M gateway. On one side we have a SIP device and on the other side of the gateway we have an E&M device.

When the E&M device terminates a call the gateway should issue a SIP BYE message to the other party. This does not happen.

Call termination, when done from the SIP device, is fine.

The IOS runniung on the 2911 router is 15.0<1>M8.

Can you please assist ?, I have added the startup-config file.

Thanks in advance .

1 REPLY
Hall of Fame Super Gold

CAS/SIP configuration

Can you take "debug vpm signal" and "debug ccsip message" for the case in question?

Please do no enable any other debug, and do not use attachmetns.

372
Views
0
Helpful
1
Replies
CreatePlease login to create content