I am running CCM 4.1.3 sr6a and I am trying to integrate a Codian/Tandberg ISDN gateway to CCM and I running into this weird issue, hope someone can help !!
- The Codian/Tandberg ISDN gateway itself has a built-in auto attendant and I've configured the ISDN gateway in CCM as an H.323 gateway and I can dial to the AA on the ISDN gateway by dialing a 4-digit extension from my video enabled phone but for some reason I am not getting the audio stream from the AA when dialing by 4-digit extension. But if I dial by IP address from a Tandberg video endpoint by passing CCM then it works, I get both video and audio streams. So I am suspecting there is something that is not right during call setup when CCM is involved.
Any suggestions / inputs is highly appreciated !!! Thank you all very much in advance !!!
Re: CCM 4.1.3 sr6a with Codian/Tandberg ISDN Gateway
The "dialplan-pattern" command creates a dial-plan pattern that specifies a global prefix for the expansion of abbreviated extension numbers into fully qualified E.164 numbers.Check the configuration of dial peer and dial pattern which might be causing the problem.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...