Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Changing origination address from non-ISDN to ISDN on AS5350 for CLID

Hi,

we are having issue with CLID when calling outside world, setup CCM -- AS5350 GW -- PSTN

this is H323 GW and PRI lines are connected to it. In the debug Q931 i can see the calling number and called number which is fine, but it doesn?t present on our mobile(Out side world)

after chasing this issue with the Telco provider, they recommend us to change

Progress Ind i = 0x8183 - Origination address is non-ISDN

Change to ISDN.

They want to change Origination address from non-ISDN to ISDN

My question:-

Is there any way where I can change the Origination ISDN type from Non-ISDN to ISDN?

GW ? AS5350

IOS - 12.3(10a)

Debug output

*Jul 8 22:20:48.402: ISDN Se2:15 Q931: TX -> SETUP pd = 8 callref = 0x656A

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9839F

Exclusive, Channel 31

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x0081, '020849XXXX'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '07872XXXXXX'

Plan:Unknown, Type:Unknown

*Jul 8 22:20:48.602: ISDN Se2:15 Q931: RX <- CALL_PROC pd = 8 callref = 0xE56A

Channel ID i = 0xA9839F

Exclusive, Channel 31

*Jul 8 22:20:52.874: ISDN Se2:15 Q931: RX <- ALERTING pd = 8 callref = 0xE56A

*Jul 8 22:20:59.778: ISDN Se2:15 Q931: RX <- CONNECT pd = 8 callref = 0xE56A

*Jul 8 22:20:59.786: ISDN Se2:15 Q931: TX -> CONNECT_ACK pd = 8 callref = 0x656A

*Jul 8 22:21:05.783: %ISDN-6-CONNECT: Interface Serial2:30 is now connected to 07872305154 unknown

*Jul 8 22:21:48.178: %ISDN-6-DISCONNECT: Interface Serial2:30 disconnected from 07872305154 , call lasted 48 seconds

*Jul 8 22:21:48.178: ISDN Se2:15 Q931: TX -> DISCONNECT pd = 8 callref = 0x656A

Cause i = 0x8090 - Normal call clearing

*Jul 8 22:21:48.338: ISDN Se2:15 Q931: RX <- RELEASE pd = 8 callref = 0xE56A

*Jul 8 22:21:48.342: ISDN Se2:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x656A02084954599

Thanks in advance

Regards,

Kazim

654
Views
0
Helpful
0
Replies
CreatePlease to create content