I have cisco 2811 and defenity prologix PBX. Now i have to configure by router as voice gateway, so pbx can through the calls. Now i want to know what interface card to be added in router and how to configure it. Please help me out.
when i search in cisco web site i found the following interfaces
1. CISCO ONE AND TWO PORT T1/E1 MULTIFLEX VOICE/WAN INTERFACE CARDS
I have the same topology. PBX (Definity G3siV11) connected to 2811. I am using VWIC-1MFT-E1.
controller E1 0/0/0
pri-group timeslots 1-31
no ip address
no logging event link-status
isdn switch-type primary-net5
isdn overlap-receiving T302 5000
isdn not-end-to-end 64
isdn protocol-emulate network
isdn incoming-voice voice
no cdp enable
timeouts initial 5
BUT I am having probems while calling from PBX phones, to E1 trunk and then to 2811. Router accept a few difits and reload itself :o/ In crashinfo I see only messages "Cause i = 0x8281 - Unallocated/unassigned number" and "%Software-forced reload " :o(
Have configured this topology yet? Is your config working?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4