i am focusing the following requirment. A cisco 2901 ISR with ISDN Interfaces is used as ISDN/SIP Voice Gateway. For outgoing calls (SIP to ISDN), the SIP User would like to provide user specific calling party address which should be transported as not-screened user provided calling party IE in the ISDN call setup.
Example (how it could work):
ISDN Rx SETUP
Bearer Capability i = 0x8090A3
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0x89
Calling Party Number i = 0x1180, '491234'
Plan:ISDN, Type:International, Screen: User-provided not screened, Presentation: allowed
In my current configuration, the 2901 is using the FROM or P-Asserted-Id of the SIP INVITE as network provided calling party. In case FROM and P-Asserted-Id are different, the P-Asserted is used as network provided only. The not-screened calling party will not be set.
Is it possible to configure the router, so the not screend calling party is set based on the FROM header (or any other header field) in the SIP INVITE?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...