Is it possible to connect a 3526 PRI gateway directly to PBX .I read the release notes on 3526 and it says we can.I am not familiar with video stuff much.If any one can explain the working it will be really helpful.
Yes... A 3526 can be hooked to a PBX. The PBX needs to provide network-side signalling to the 3526. The 3526 supports a number of PRI signalling types including 5ESS, 4ESS, NI2, DMS100, etc... so it should be pretty flexible in working with various PBXs. Note, that you may also need a CSU. Hope this helps
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...