Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco 9032 Encoder

I have a Cisco 9032 encoder.  I see where to set the IP network information but I don't see where the devices auto-negotiation is set.  My 7609 is set to 100/full hard set.  I'm getting runt errors and I'm wondering is this due to the encoder not being able to do a 100/full.  When the router is set to auto i'm getting 100/half.  I would just like to know for sure if the encoder in fact only can do 100/half.

Thanks

Jared

694
Views
0
Helpful
0
Replies
CreatePlease to create content