In a post half a page down from where you have posted this question, there is another thread, CISCO D9034 ENCODER, where similar VII and EDH errors were mentioned. In the other thread, these were fixed by repairs to the power hardware within the device. If yours is doing similar, then it's likely faulty hardware which you can fix via RMAing the device through Cisco (assuming you have an active Service Contract), or finding an out-of-warranty repair company that would be able to fix it for you.
Wayne -- Please remember to rate responses and to mark your question as answered if appropriate.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...