Hi! I would like to make a network design with the cisco ip VC solution. I would like to use it in my lan. The point is that i have few vpn remote clients, with diffent bandwidth services for each one: modem (56K), T1, ISDN, and so on. Would it be possible to give them videoconf. services as if they were local clients (VPN) using a campus single/multimode model instead of extending IP VC services to a WAN single/multimode model? Would the bandwidth be enough to provide them with good services?
I think you have to compromise with the quality if you are using 56k connection, T1 lines are fine , please refer this document for more details regarding designing and choosing the type of network that should be used
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...