I'm having difficulty getting the GW2P module to match the National ISDN signaling from the teleco. I had the teleco tech come on site and verify that NI-1 signal is coming from the teleco. The problem is Cisco does not say if the GW2P is using NI-1 or NI-2. Thoughts?
Thanks for the information. I read several other technical documents for voice gateways and PRI lines which spoke specifically about DMS-100, 5ESS, and NI-2, but never found anything on the subject for the GW2P.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.