I'm currently building a set of configurations to implement QOS over a voip network. I've identified the voip signaling traffic which uses H323 fast start - TCP 1720 using an access-list which works fine. In order to keep the config as tight as possible I'd like to use a custom protocol to identify tcp port 1720 instead of an access-list. The command below indicates that you can create your own custom protocols to apply to the match statement. Does anyone know how you create these custom protocols?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...