Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CLI on CME

Hi,

I have a problem sending out my number when calling out via PSTN. How do I enable or configure CLI so that my main number will be displayed on the receiver's phone?

Your input will be highly appreciated.

Thanks

8 REPLIES
Hall of Fame Super Gold

Re: CLI on CME

Hi, there is more than one way.

The simpler one, under isdn interface, configure "isdn calling-number XXX".

Please rate post if it helps!

New Member

Re: CLI on CME

I tried it and still not working. what else can I try?

Hall of Fame Super Gold

Re: CLI on CME

Do "debug isdn q931" with "term mon" and check calling number as wll plan/type.

New Member

Re: CLI on CME

I can see it from the debug messages.

Jul 1 12:32:33.415: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x6CC0

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98381

Exclusive, Channel 1

Progress Ind i = 0x8183 - Origination address is non-ISDN

Calling Party Number i = 0x0180, '0126851300'

Plan:ISDN, Type:Unknown

Called Party Number i = 0x81, '0112089153'

Plan:ISDN, Type:Unknown

Hall of Fame Super Gold

Re: CLI on CME

Is 0126851300 your main number ?

If yes, ask telco if they want a plan/type set differently than ISDN/Unknown, as it is now.

If no, configure "isdn calling-number" with the right number.

New Member

Re: CLI on CME

thanks. will do

New Member

Re: CLI on CME

Thank you very much. it is now working. it was the telco problem.

Hall of Fame Super Gold

Re: CLI on CME

No problem, please remember to rate useful posts!

235
Views
5
Helpful
8
Replies