I have a CME on a 2800 router - this router has NO PSTN card, so i am trying to setup using an AS5300 GW which is already setup and working for VoIP. When i config CME outbound calls are working fine, but cannot seem to get the inbound main number to route in the CME. I have debugged CCSIP and can see the incmoing call, but fails to 404. I have setup various trans rules and dial-peers but still get 404 - or NU on client.
Any one done this before - if so how did you set it up ?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...