Command Problem

[ufuk-guler]

Here is my running-config file. I run

"CANTAS(config-if-atm-vc)#service-policy output SES" command under PVC 0/35. After this command i dont take any error messages. But this service doesn't work.When I check running-config again i can not see this command under pvc. And i run "show policy-map interface atm 0/0.1" but see nothing. How can i start this service correctly. Thank for everthing.

[j-block]

In 7500 running 12.2.s provider does not support the service-policy command. Try 12.2.S jsv image no the pv image