Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

condition overflow

Hi,

I configure the XM with IPIP function and it works fine. However, I find that some calls will go to dial-peer 4403. It seems that some calls fail to terminate to dial-peer 4401 and 4402, it flows to dial-peer 4403.

I would like to enable the "condition overflow" function below

- All calls must go to dial-peer 4401 and 4402 for normal situration. The call will not flow to dial-peer 4403 if the gateway 192.168.16.20 OR 192.168.17.120 are up.

- When the gateway 192.168.16.20 AND 192.168.17.120 are down, the calls should flow to dial-peer 4403 only.

How do I change the configuration?

rdgs

R1

dial-peer voice 4401 voip

no prefer

destination-pattern 44.

session target ipv4:192.168.16.120

dial-peer voice 4402 voip

prefer 1

destination-pattern 44.

session target ipv4:192.168.17.120

dial-peer voice 4403 voip

Description: Internet

prefer 2

destination-pattern 44.

session target ipv4:202.x.x.x

4 REPLIES

Re: condition overflow

try the following

dial-peer voice 4401 voip

destination-pattern 44.

session target ipv4:192.168.16.120

dial-peer voice 4402 voip

prefer 1

hunt-stop

destination-pattern 44.

session target ipv4:192.168.17.120

dial-peer voice 4403 voip

Description: Internet

prefer 3

destination-pattern 44.

session target ipv4:202.x.x.x

New Member

Re: condition overflow

Hi,

I try it but the call cannot overflow to "4403" dial peer. There is one call leg only, router cannot find the right dial-peer (voip) when 192.168.x.x gateway are down.

If I enable the gateway, the call can over flow from 4401 to 4402.

Anything I missing?

rdgs

Re: condition overflow

try ur origianl config with this voice-calss and simple chabge as the following:

voice class h323 1

h225 timeout tcp establish 3

dial-peer voice 4401 voip

preference 0

voice-class h323 1

destination-pattern 44.

session target ipv4:192.168.16.120

dial-peer voice 4402 voip

prefer 1

voice-class h323 1

destination-pattern 44.

session target ipv4:192.168.17.120

dial-peer voice 4403 voip

Description: Internet

prefer 2

destination-pattern 44.

session target ipv4:202.x.x.x

and make sure u have the right routing config

i mean u ca ping the internet host and u have two routes! some times it be routing issue!!

good luck

and let me

New Member

Re: condition overflow

Hi,

Some calls still flow to dial-peer 4403 if 4401 and 4402 fail to terminate the calls.

Any work around or solution for "condition overflow"? Thanks

rdgs

160
Views
0
Helpful
4
Replies
CreatePlease to create content