Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuration example for fractional T1

Hi,

I have a module VWIC2-2MFT-T1/E1 in 2811 and will purchase a signle fractional T1 from carrier with 10 channels to data and another 10 to voice.

Can I have a configuration example to achieve this to cover data and voice both in single T1 interface?

Thanks in advance,

5 REPLIES

Re: configuration example for fractional T1

card-type t1 0

controller t1 0/0

pri-group time 1-10,23

linecode b8zs

framing esf

clock source line

network-clock-select 1 t1 0/0

That's the PRI part, at least.

New Member

Re: configuration example for fractional T1

Hi,

Can this fractional T1 be managed with MGCP in CUCM 6.x?

Regards,

Julien

Hall of Fame Super Gold

Re: configuration example for fractional T1

Yes.

Re: configuration example for fractional T1

Hi Julien,

It can be - but you have to change service parameters to make sure that CUCM sees the other channels as out of service. There's a specific service parameter just for this.

They are these values - "Change B-Channel Maintenance Status 1" and so on. The help information for them can guide you on the syntax.

hth,

nick

New Member

Re: configuration example for fractional T1

Thanks guys,

I figured out how to configure both type(data and voice) into single T1 interface. my case channel 1-10 to voice and 11-20 to data.

!

controller t1 0/0

linecode b8zs

framing esf

pri-group time 1-10,23

channel-group 0 time 11-20

!

John

1163
Views
0
Helpful
5
Replies
CreatePlease to create content