cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1945
Views
0
Helpful
5
Replies

configuration example for fractional T1

cjrchoi11
Level 1
Level 1

Hi,

I have a module VWIC2-2MFT-T1/E1 in 2811 and will purchase a signle fractional T1 from carrier with 10 channels to data and another 10 to voice.

Can I have a configuration example to achieve this to cover data and voice both in single T1 interface?

Thanks in advance,

5 Replies 5

card-type t1 0

controller t1 0/0

pri-group time 1-10,23

linecode b8zs

framing esf

clock source line

network-clock-select 1 t1 0/0

That's the PRI part, at least.

Hi,

Can this fractional T1 be managed with MGCP in CUCM 6.x?

Regards,

Julien

Yes.

Hi Julien,

It can be - but you have to change service parameters to make sure that CUCM sees the other channels as out of service. There's a specific service parameter just for this.

They are these values - "Change B-Channel Maintenance Status 1" and so on. The help information for them can guide you on the syntax.

hth,

nick

Thanks guys,

I figured out how to configure both type(data and voice) into single T1 interface. my case channel 1-10 to voice and 11-20 to data.

!

controller t1 0/0

linecode b8zs

framing esf

pri-group time 1-10,23

channel-group 0 time 11-20

!

John

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: