Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configure two VWIC2-1MFT-E1

Hi,

Currently i have a Cisco 2851 router with 1 VWIC-1MFT-E1 installed and just added another VWIC-1MFT-E1.

Please advise on the config on how should I add both E1 card to the same group.(the second ISDN30 is a slave ISDN bt Telco).

The changes config will be as follows:

controller E1 0/1/0

pri-group timeslots 1-31 service mgcp

!

controller E1 0/2/0

pri-group timeslots 1-31 service mgcp

!

interface Serial0/1/0:15

no ip address

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

interface Serial0/2/0:15

no ip address

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable

Is this correct ? Thanks in Advance

6 REPLIES

Re: Configure two VWIC2-1MFT-E1

Yes, assuming you're running MGCP, this is correct. In Callmanager, you will need to create a Route Group for each E1 and then create a Route List that includes both Route Groups. Then assign this Route List to Route Patterns.

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Configure two VWIC2-1MFT-E1

Hi Brandon,

Thanks for your prompt reply.

Now I faced some error

5vgw1(config-controller)#pri-group timeslots 1-31 service mgcp

% Not enough DSP resources available to configure pri-group on controller E1 0/2

/0

% The remaining dsp resources are enough for 18 time slots.

% For current codec complexity, 1 extra dsp(s) are required to create this voice

port.

Is that mean that i need 2 purchase DSP module ?

Pls advise as i am new in VoIP.

Thanks

New Member

Re: Configure two VWIC2-1MFT-E1

Hi Brandon,

I managed to find out the the current 2851 router has only PVDM2-48 installed.

I may need 2 purchase PVDM2-16 to support 2 E1 card.

Is it correct ? I do not think i need 2 purchase any license as it route to the Call Manager

Appreciated your kind reply.

New Member

Re: Configure two VWIC2-1MFT-E1

Try this...

interface Serial0/1/0:15

trunk-group PSTN-E1 1

interface Serial0/2/0:15

trunk-group PSTN-E1 2

Hall of Fame Super Red

Re: Configure two VWIC2-1MFT-E1

Hi Norman,

Yes, you are correct here. You are short 12 DSP resources to complete the 30 channel E1. You would need to order at least the part you suggested PVDM2-16 (48 + 16 = 64 channels). There are no additional licenses required. Here is a good doc;

http://www.cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8016e845.html

Hope this helps!

Rob

New Member

Re: Configure two VWIC2-1MFT-E1

Hi rob,

Thanks for your reply.

Based on Brandon recommendation the configuration for cisco router and call manager should be correct.

Will updated you once finished. Thank both of you

261
Views
0
Helpful
6
Replies
CreatePlease to create content