Configuring 3xCS3662 with 12 VIC-2E&M each - How?

ovieira · ‎02-11-2003

Hi!

I'd like to know how to configure a dialplan for a VoIP network in wich i have 3xCS3662 with 12 VIC-2E&M to connect to a single PABX using the total 72 ports, on each site. The purpose is to have a unic local numbering plan at each site, and, when a person wants to place a call to a remote site just dials the dialpan and doesn't have to decide wich of the 72 E&Ms is going to use. One other way to put this question is to know how can i group a few routers, each with a number of voice ports, using s single numbering plan.

Report Inappropriate Content · ‎02-17-2003

I am not very clear with your question, but if you are looking for some help on dial plans/call routing, you will find a number of docs on this topic here.

http://www.cisco.com/cgi-bin/Support/browse/psp_view.pl?p=Internetworking:Voice_Call_Routing_Dial_Plans&viewall=true

ovieira · ‎02-18-2003

Hi!

Thanks for your reply. The question is how to make a global multi-chassi dial-plan! Iwant to configure 3xCS3662 (with 24 E&Ms each) to make them 72 E&M total.

Regards,

olindo

Report Inappropriate Content · ‎02-19-2003

Assuming you have CM behind these boxes, you can group them together using route groups. For eg. you can configure one route pattern 9.! and add the 3 gateways into the route group. You can find more help on route groups here.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00800c2f96.html

Hope it helps

ovieira · ‎02-19-2003

Hi!

In fact i don't have any CM. It's just a "simple" VoIP network were i can put a Gatekeeper to manage all the VoIP gateways.

Regards,

Olindo