Normally, in my pretty limited experience configuring gateways, I would configure a dial peer, a destination pattern and a session target. Maybe some specifics would also be entered for codec type, but the thrust of it is as I understand it:
Corresponding gateway relevent to above pattern match
Now assuming I have a video endpoint which is registed to a gatekeeper, it makes a call to an IP address, the gatekeeper it is registerd to then forwards the call to this gateway, how on earth do I get this gateway (CUBE flow-through) to get the call and forward it on to the internet for call routing?
Regarding the two bullets above this translates into
.T (i.e. anything)
The IP default gateway to the Internet?
Has anyone done something similar to this previously? Or can point me to a SRND?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.